MTI Propane/Nat Gas Detector 12V Surfac MTI 40441PWT

MTI Propane/Nat Gas Detector 12V Surfac MTI 40441PWT

• FALSE ALARM RESISTANT - Our InteleCheck™ circuit eliminates false alarms caused from momentary exposure to LP Gas aerosols or to out gases. This allows for complete installation and testing during production.


• FULLY OPERATIONAL DURING MUTE CYCLE - Life safety is our first priority complete protection. If a leak is detected and the alarm is muted by the RVer, the Safe T Alert™ detector continues to provide complete protection. Every 30 seconds the LED will flash red and the unit will chirp to let you know that a dangerous condition still exists. Once the gas is cleared the unit resets, it will immediately alarm if high levels of gas reoccur - even during the mute cycle.


• RAPID DIAGNOSTIC TEST - No Hazardous Gas Required! With a touch of the Test Switch the microprocessor performs a full diagnostic analysis, including sensor circuit operator, verifying the alarm is working within specifications. Other manufacturers require the use of hazardous gas test, which can cause permanent sensor damage.


• WIDEST OPERATIONAL VOLTAGE RANGE, 7 TO 16 VOLTS DC - The 40 series alarm will operate until the battery is down to 7 volts, without an annoying low battery warning alarm. Other detectors alarm at 10 volts causing irate RVers and dealers to disconnect the unit.


• POWER MISER - Uses only 46 mA of current. Combined with a wider operational voltage range the Safe T Alert™ alarm eliminates field problems and associated warranty - service calls.

Description: Surface
Cut Out: 3" x 5-1/2"

SKU: MTI 40441PWT
Manufacturer Part Number: 40-441-P-WT
Product Category: RV Appliances>Fume Detectors